Let's start by saying that the repair of your hot tub's electric dryer when the heater is not hard to do a job, if you know what to look.
The heating circuit of Whirlpool electric dryer consists of the following parts. The timer, the heater, the HI-Limit thermostat, safety thermostat, operating thermostat, the temperature switch and the motor centrifugal switch.
If any of these are not, the heat is not a dryer. Well, most people, when the dryer is no longerHeating, replace the heater or the timer with controls to make sure that these parts are bad. Rule number one is to not assume that the part out of the review with a multimeter is bad.
The first and most important thing you need to do is, to the dryer from the wall outlet before you disconnect any kind of work on them. Most parts need to check for continuity, and the dryer must be disconnected from the socket.
Most of the time, the role which theProblem is, behind the dryer and you can access by winning the back.
On the back of the dryer is removed. Disconnect one of the heater wires and a reading between the two terminals on the heating element. The reading should be between 10 and 50 Ohm. When the heater is good, control of HI-Limit thermostat by one of the lines and checking for continuity. Continuity means that electricity could happen that you are part of the test.
TheHELLO limit blows when there is an obstacle in the exhaust hose, so make sure the exhaust hose is not obstructed, if instead of the HI-Limit kit.
If the HELLO-limit thermostat and the heating element is ok, check the operating thermostat. The operating thermostat is to maintain the temperature within the drum at about 150 degrees. They must be of the two terminals with the red wires to verify related.
In which the parts that are not more often inWhirlpool electric dryer. The timer, the motor centrifugal switch, temperature switches are a bit harder to verify because there are different one. You must use your wiring diagram to see how to control them.
0 ความคิดเห็น:
แสดงความคิดเห็น