Silky blouse, diapers, muddy sleeping bag from that camping trip or any other clothes you have a Kenmore washer and dryer can handle it. And Kenmore is certainly a name with a reputation you can trust. But sometimes you need to repair a Kenmore dryer. Great news parts are available.
Here are 6 of the most common parts, you may need to invest in the course of time.
1. Tune Up Kit
A Tune Up Kit has 3 parts that have to be replaced usually every 5 years orso. The kit has a new belt, new idler puller, and new drum support rollers. It is even complete with instructions on how to do the replacement.
2. Element Kit
Comes with terminal adapters as well as the element.
3. Thermal Fuse
In the later models you will find that there is a short element in the lower half of the burner box which also houses the thermal fuse which may occasionally need replacing.
4. Gas Dryer Igniter
If your dryer isn’t throwing any Heat you should check the fuse, if it do not work stopped. It is to remedy a quick and easy.
5. Gas Valve Coil Kit
Repair your gas valves for a fraction of the cost of replacement.
6. Heat-blocking filter kit
Includes the HI-limit thermostat and thermal fuse.
If it does not work at all, there are some things you can try.
1. No Power
Make sure the power cord plugged Unplug the power cord and plug it again check the surf, if itnot triggered, or that a fuse not blown. You can also use a voltmeter to check the plug itself, to make sure it is the power going into the socket.
2. Door
At the door, a switch or sensor is expressed by closing the door, she is active against a lever, then a door switch that can start the dryer. When the lever is broken, the switch can not be activated and then the dryer can not be started. You may need to replace this lever.
3. ThermalFuse
Almost every dryer on the market has a thermal fuse. This fuse will burn if the dryer overheats. When this happens, two things happen. The dryer does not work, either completely or it runs, but it casts no heat. We find this fuse under the duck in the dryer vent. If the fuse is blown you want to replace it.
4. Defective timer
Occasionally, the timer is on a dryer can be broken, so even if you use the dryer on it turneddoes not recognize the motion and allow the dryer does not start.
And here are some good tips on how to determine what happens to your dryer.
1. Gas valve coils
If the fuse is lit, but it will be shut down before the gas ignited, the coil is either worn out or damaged. Replace the two coils.
2. Flame Sensor
The flame sensor may be worn and must be replaced. You can find the sensor near the igniter is located.
3. Vents
Lint collectsin the dryer so you check the vent hose and discharged, to ensure there are no clogs. You must also ensure that you regularly clean the air in the dryer, since it reduces the efficiency of the dryer and increases the risk of fire.
4. Thermostat
A dryer is a thermostat that regulates the heating cycles, and if your dryer is not heating properly, this is the most common cause.
5. Thermal fuse
When the dryer, the thermal fuse will burn out with overheating means that yourDryer will either not run or it runs, do not throw but no heat. . Replace
6. Detonators
The fuze system is very fragile, so it can be easily broken. Replace if necessary.
This Kenmore dryer repair tips are a great place to start. If that does not work, maybe it's time for a mechanic Kenmore call. But why not try your hand at a first repair?
0 ความคิดเห็น:
แสดงความคิดเห็น